Setup Router logo in white Setup router name logo in white
Get Software

Reset the Netgear D6200

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 4 minutes

This guide shows you how to reset your Netgear D6200 router. This is not the same thing as rebooting a router. Turning a router off and back on again causes a reboot. However, when you reset a router you, return it back to its factory default settings.

Warning: Proceed with caution; resetting your router can be a major headache. When you reset your router, the following will happen.

  • The router's login credentials are reset to factory defaults.
  • Your WiFi name and password are reset.
  • Any ISP settings saved in your router will be removed. You may have to contact your ISP.
  • Any parental controls, firewall settings, or port forwards will be removed.

A router reset should be considered the last resort when you cannot log in to your router any other way. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Netgear D6200 Guides

This is the reset router guide for the Netgear D6200 v1.1.00.36_1.00.36 (IT). We also have the following guides for the same router:

Recover Password in Netgear D6200

Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.

Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Just keep in mind that a router reset should be done as the last resort when you are unable to login to your router.

Reset the Netgear D6200

Most of the time you can find a small reset button located on either the back or the bottom of a router. Look at your router and try to find something that looks like this:

Router Reset Button

Your reset button may look different, but usually they are very small. You might find a pinhole on the back of the router that requires a paper clip to push the button hidden under it.

Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Don't forget, this step will totally reset your Netgear D6200 router back to factory settings.

This last step should only be taken if you have tried everything else, such as using our Router Password Finder software, which can recover lost or forgotten router passwords.

Login to the Netgear D6200

Now you need to log in using the factory default username and password. You can find all of the information that you need in our D6200 Login Guide.

Change Your Password

Do not forget to change your router's default password when you log back into it. It is a huge security risk to leave your router's password set to the factory default. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: Put your new password on a post-in note and stick it to the bottom of your router.

Other Netgear D6200 Guides

If you want additional help with your Netgear D6200 be sure to check out some of our other guides.

This is the reset router guide for the Netgear D6200 v1.1.00.36_1.00.36 (IT). We also have the following guides for the same router: