How to change the IP Address on a Netgear WNR1000v3 Genie router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the Netgear WNR1000v3 Genie router.

Other Netgear WNR1000v3 Genie Guides

This is the ip address guide for the Netgear WNR1000v3 Genie.We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Netgear WNR1000v3 Genie

To get started configuring the Netgear WNR1000v3 Genie LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Netgear WNR1000v3 Genie, follow our Netgear WNR1000v3 Genie Login Guide.

Change the LAN IP Address on a Netgear WNR1000v3 Genie

If you followed our login guide above then you should see this screen.

router setup
This is the setup page from your Netgear router.

After you've logged into the Netgear WNR1000v3 Genie router you'll be taken to the Home page. To get started changing your IP address click the tab labeled ADVANCED near the top of the page. From there click Setup and then LAN Setup below that.

Configure the LAN section of your Netgear WNR1000v3 Genie

router IP address lan home network
This is the lan page from your Netgear router.

This takes you to the page you see here.

On this new page you can change your router's IP Address. Don't know what you should change it to? A good option is 10.0.0.1

Below that you'll see the IP Subnet Mask. Make sure not to change this. It needs to stay at 255.255.255.0

Congratulations! You're finished. Just don't forget to Apply your settings before leaving the page.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Netgear WNR1000v3 Genie Info

Don't forget about our other Netgear WNR1000v3 Genie info that you might be interested in.

This is the ip address guide for the Netgear WNR1000v3 Genie.We also have the following guides for the same router: