Setup Router logo in white Setup router name logo in white
Get Software

Reset the Netgear WNR1000v3 Genie

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

This guide shows you how to reset your Netgear WNR1000v3 Genie router to factory default settings. This is not the same thing as rebooting a router. Turning a router off and back on again causes a reboot. However, when you reset a router you, return it back to its factory default settings.

Warning: Proceed with caution; resetting your router can be a major headache. The following settings will be changed in your router:

  • The router's login and password are reset.
  • All WiFi information such as network name, password, and authentication method are erased.
  • Your ISP settings are reset, which means you will have to contact your ISP to get them back.
  • Any port forwards, firewall settings, or parental controls that you have configured will be removed.

Resetting your router should be considered the last step. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.

Other Netgear WNR1000v3 Genie Guides

This is the reset router guide for the Netgear WNR1000v3 Genie. We also have the following guides for the same router:

Recover Password in Netgear WNR1000v3 Genie

Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.

Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.

Router Password Finder - Recover Lost or Forgotten Router Passwords

Only after you have tried to recover your missing router username and password should you perform a full router reset.

Reset the Netgear WNR1000v3 Genie

On most routers you can find a small button on the back or the bottom labeled reset. This is what a typical reset button looks like:

Router Reset Button

Yours may look slightly different, but they are usually tiny. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.

Watch the lights on the front of your router and hold the reset button down for about 10 seconds. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Keep in mind that this will completely reset your Netgear WNR1000v3 Genie router.

Only do this once you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Netgear WNR1000v3 Genie

Now that you have finished resetting the router, you need to login to the router interface using the default username and password. We have a WNR1000v3 Genie Login Guide with all this information ready for you.

Change Your Password

After logging in, you should really change your router's password for added security. The factory default passwords for routers are very well known. Our Choosing a Strong Password guide talks about choosing a strong password for your router.

Tip: Write your new password down on a post-it note and stick it to the bottom of your router.

Other Netgear WNR1000v3 Genie Guides

This isn't our only Netgear WNR1000v3 Genie guide. We also have the following guides for this router.

This is the reset router guide for the Netgear WNR1000v3 Genie. We also have the following guides for the same router: