Setup Router logo in white Setup router name logo in white
Get Software

Reset the Quicktel QAR367E4W

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

This article covers how to reset the Quicktel QAR367E4W router back to factory default settings. A router reset is very different than a router reboot. Unplugging a router from the wall reboots it. This is very different from a reset, which erases a router completely and returns it to factory default settings.

Warning: This is not a step to be taken lightly. A router reset will affect the following settings:

  • The router's login and password are reset.
  • All WiFi information such as network name, password, and authentication method are erased.
  • All ISP settings will reset to default, and you may have to contact your ISP.
  • Any parental controls, firewall settings, or port forwards will be removed.

A router reset should be considered the last resort when you cannot log in to your router any other way. Before you reset your router you may want to try recovering your router password with our Router Password Finder.

Other Quicktel QAR367E4W Guides

This is the reset router guide for the Quicktel QAR367E4W. We also have the following guides for the same router:

Recover Password in Quicktel QAR367E4W

Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Automatically Recover Lost or Forgotten Router Passwords

If you are unable to recover your lost router password, then you may have to proceed with a full router reset.

Reset the Quicktel QAR367E4W

Most routers have a small button on either the back or the bottom. A typical reset button looks like this:

Router Reset Button

Even though yours may look slightly different, you need to look for a tiny button. Sometimes the button is under a pinhole, and you need a paper clip to push it.

Watch the lights on the front of your router and hold the reset button down for about 10 seconds. After a few seconds the lights should blink differently. When this happens, the reset is complete. Do not be concerned about holding the reset button down too long. It will not hurt anything.

Keep in mind that this will completely reset your Quicktel QAR367E4W router.

Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Quicktel QAR367E4W

After you are finished resetting your router, you need to login in using the original factory username and password. Just follow our QAR367E4W Login Guide to find all of the information that you need.

Change Your Password

You need to change your router's default password after you log in for the first time. It's a very bad idea to leave your router's password set to the factory default. Our Choosing a Strong Password guide can help you pick a strong password for your router.

Tip: Write your new password down on a post-it note and stick it to the bottom of your router.

Other Quicktel QAR367E4W Guides

This isn't our only Quicktel QAR367E4W guide. We also have the following guides for this router.

This is the reset router guide for the Quicktel QAR367E4W. We also have the following guides for the same router: