Setup Router logo in white Setup router name logo in white
Get Software

Reset the TP-Link Archer D9

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

If you need to reset your TP-Link Archer D9 router back to factory settings, then this article shows you how. Resetting a router is different than rebooting a router. Unplugging a router from the wall reboots it. A Router Reset completely erases the router and returns it to factory settings.

Warning: This is not a step to be taken lightly. A router reset will affect the following settings:

  • The router's login and password are reset.
  • Your WiFi name and password are reset.
  • Your ISP username and password will be reset, and you may have to contact your ISP.
  • All parental controls, firewall settings, and port forwards will be removed.

A router reset is the last step you should take in recovering your router's password. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other TP-Link Archer D9 Guides

This is the reset router guide for the TP-Link Archer D9 0.9.1 0.1 v0041.0. We also have the following guides for the same router:

Recover Password in TP-Link Archer D9

Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Just keep in mind that a router reset should be done as the last resort when you are unable to login to your router.

Reset the TP-Link Archer D9

Most routers have a small button on either the back or the bottom. A typical reset button looks like this:

Router Reset Button

Your reset button may look different, but usually they are very small. You might find a pinhole on the back of the router that requires a paper clip to push the button hidden under it.

Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. Notice how the lights on the front of the router are blinking. When the lights do something different, the router is reset. Do not be concerned about holding the reset button down too long. It will not hurt anything.

Keep in mind that this will completely reset your TP-Link Archer D9 router.

This last step should only be taken if you have tried everything else, such as using our Router Password Finder software, which can recover lost or forgotten router passwords.

Login to the TP-Link Archer D9

After you are finished resetting your router, you need to login in using the original factory username and password. You can find all of the information that you need in our Archer D9 Login Guide.

Change Your Password

Do not forget to change your router's default password when you log back into it. Leaving a router password set to default is a very serious security risk. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: Put your new password on a post-in note and stick it to the bottom of your router.

Other TP-Link Archer D9 Guides

We have collected a lot of information about the TP-Link Archer D9 router. You can find some of our additional content here.

This is the reset router guide for the TP-Link Archer D9 0.9.1 0.1 v0041.0. We also have the following guides for the same router: