Reset the Arris BGW210-700

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 7 minutes

If you need to reset your Arris BGW210-700 router back to factory settings, then this article shows you how. A router reset is a much bigger deal than a router reboot. Rebooting a router is simply turning it off and back on again. This is very different from a reset, which erases a router completely and returns it to factory default settings.

Warning: Before you continue, there are a few things you need to know. The following settings in your router will be changed:

  • The router's login and password are reset.
  • All WiFi information such as network name, password, and authentication method are erased.
  • Your ISP username and password will be reset, and you may have to contact your ISP.
  • Any port forwards, firewall settings, or parental controls that you have configured will be removed.

A router reset should be considered the last resort when you cannot log in to your router any other way. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.

Other Arris BGW210-700 Guides

This is the reset router guide for the Arris BGW210-700 2.6.4 AT&T. We also have the following guides for the same router:

Recover Password in Arris BGW210-700

Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.

Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.

Router Password Finder - Automatically Recover Lost or Forgotten Router Passwords

If you are unable to recover your lost router password, then you may have to proceed with a full router reset.

Reset the Arris BGW210-700

Most of the time you can find a small reset button located on either the back or the bottom of a router. Most reset buttons look like this:

Router Reset Button

Your reset button may look different, but usually they are very small. You might find a pinhole on the back of the router that requires a paper clip to push the button hidden under it.

Hold the reset button down for 10 seconds and watch the lights. Notice how the lights on the front of the router are blinking. When the lights do something different, the router is reset. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Remember, this will erase everything you have previously done to this Arris BGW210-700 router.

Be sure to only reset your router if you have tried everything else, such as running our Router Password Finder software, which can find your lost or forgotten router password for you.

Login to the Arris BGW210-700

After you are finished resetting your router, you need to login in using the original factory username and password. We have a BGW210-700 Login Guide with all this information ready for you.

Change Your Password

After logging in, you should really change your router's password for added security. Leaving a router password set to default is a very serious security risk. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: A great place to write your new password down is on a piece of paper taped to the bottom of your router.

Other Arris BGW210-700 Guides

We have collected a lot of information about the Arris BGW210-700 router. You can find some of our additional content here.

This is the reset router guide for the Arris BGW210-700 2.6.4 AT&T. We also have the following guides for the same router: