How to change the IP Address on a Dlink DIR-625 router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 4 minutes

This page shows how to change the LAN IP Address on the Dlink DIR-625 router.

Other Dlink DIR-625 Guides

This is the ip address guide for the Dlink DIR-625. We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

  • 192.168.0.1
  • 192.168.1.1
  • 10.0.0.1

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Dlink DIR-625

To get started configuring the Dlink DIR-625 LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Dlink DIR-625, follow our Dlink DIR-625 Login Guide.

Change the LAN IP Address on a Dlink DIR-625

If you followed our login guide above then you should see this screen.

router setup
This is the setup page from your Dlink DIR-625 router.

Once you have logged into the Dlink DIR-625 you begin on the SETUP page of your Router. To change the IP Address, the address you are looking at while inside the network, click the blue box on the left labeled NETWORK SETTINGS.

Configure the LAN section of your Dlink DIR-625

router setup
This is the setup page from your Dlink DIR-625 router.

This opens up a new page, where you need to scroll down the page until you come to the box labeled Router IP Address. Enter the new address you have chosen in this box. Our recommendation is 192.168.0.1 for this particular Router.

Please don't change the Subnet Mask, it should remain at 255.255.255.0, and the DHCP Server should remain enabled.

For the changes to take effect, click Save Settngs, located at the top of the page.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Dlink DIR-625 Info

Don't forget about our other Dlink DIR-625 info that you might be interested in.

This is the ip address guide for the Dlink DIR-625. We also have the following guides for the same router: