Setup Router logo in white Setup router name logo in white
Get Software

Reset the TP-Link Archer GX90

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 4 minutes

This is the reset guide for the TP-Link Archer GX90 router. This is a much bigger deal than a router reboot. Turning a router off and back on again causes a reboot. However, when you reset a router you, return it back to its factory default settings.

Warning: Make sure that you fully understand the following before resetting your router. A router reset will affect the following settings:

  • The router's username and password are reset to factory defaults.
  • All WiFi information such as network name, password, and authentication method are erased.
  • All ISP settings will reset to default, and you may have to contact your ISP.
  • All parental controls, firewall settings, and port forwards will be removed.

A router reset should be considered the last resort when you cannot log in to your router any other way. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.

Other TP-Link Archer GX90 Guides

This is the reset router guide for the TP-Link Archer GX90 1.1.2. We also have the following guides for the same router:

Recover Password in TP-Link Archer GX90

If the only reason that you are resetting your router is because you forgot your router password, then you may want to try running our Router Password Finder instead of resetting your router.

Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.

Router Password Finder - Automatically Recover Lost or Forgotten Router Passwords

A router reset should be the last thing you try if you are unable to login.

Reset the TP-Link Archer GX90

Most routers have a small button on either the back or the bottom. Most reset buttons look like this:

Router Reset Button

Yours may look slightly different, but they are usually tiny. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.

Hold the reset button down for 10 seconds and watch the lights. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. You can hold the button down as long as you like, it will not hurt anything.

Keep in mind that this will completely reset your TP-Link Archer GX90 router.

This last step should only be taken if you have tried everything else, such as using our Router Password Finder software, which can recover lost or forgotten router passwords.

Login to the TP-Link Archer GX90

Once the reset is complete, you need to login to your router using the default IP address, username, and password. We have a Archer GX90 Login Guide with all this information ready for you.

Change Your Password

After logging in, you should really change your router's password for added security. The factory default passwords for routers are very well known. Our Choosing a Strong Password guide talks about choosing a strong password for your router.

Tip: After creating this new password, we highly recommend writing this down on a post-it note and attaching it to the bottom of your router for future reference.

Other TP-Link Archer GX90 Guides

We have collected a lot of information about the TP-Link Archer GX90 router. You can find some of our additional content here.

This is the reset router guide for the TP-Link Archer GX90 1.1.2. We also have the following guides for the same router: