Setup WiFi on the ZTE ZXV10 W300

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 4 minutes

The ZTE ZXV10 W300 router is considered a wireless router because it offers WiFi connectivity. WiFi, or simply wireless, allows you to connect various devices to your router, such as wireless printers, smart televisions, and WiFi enabled smartphones.

Other ZTE ZXV10 W300 Guides

This is the wifi guide for the ZTE ZXV10 W300 v5. We also have the following guides for the same router:

WiFi Terms

Before we get started there is a little bit of background info that you should be familiar with.

Wireless Name

Your wireless network needs to have a name to uniquely identify it from other wireless networks. If you are not sure what this means we have a guide explaining what a wireless name is that you can read for more information.

Wireless Password

An important part of securing your wireless network is choosing a strong password.

Wireless Channel

Picking a WiFi channel is not always a simple task. Be sure to read about WiFi channels before making the choice.


You should almost definitely pick WPA2 for your networks encryption. If you are unsure, be sure to read our WEP vs WPA guide first.

Login To The ZTE ZXV10 W300

To get started configuring the ZTE ZXV10 W300 WiFi settings you need to login to your router. If you are already logged in you can skip this step.

To login to the ZTE ZXV10 W300, follow our ZTE ZXV10 W300 Login Guide.

Find the WiFi Settings on the ZTE ZXV10 W300

If you followed our login guide above then you should see this screen.

router status mac address internet IP
This is the status page from your ZTE ZXV10 W300 router.

We begin this wireless setup guide on the Status page of the ZTE ZXV10-W300v5 router. To start off, click the Interface Setup tab located at the top of the page. Then under that pick the the option of Wireless in the smaller orange bar.

Change the WiFi Settings on the ZTE ZXV10 W300

wifi wireless
This is the wifi setup page from your ZTE ZXV10 W300 router.

This takes you to a new page.

Start by setting the Channel to either 1, 6, or 11. To learn why this is important, check out our WiFi Channels Guide.

Now for the SSID. This can be anything you like and will serve as your network identification. For more information, take a look at our Wireless Names Guide.

Next, be sure the Authentication Type is set to WPA2-PSK. Why is this the best option? See our WEP vs. WPA Guide to find out.

Below that, be sure the Encryption is set to AES.

Finally, you need to set a password. A strong passowrd contains 14-20 characters and contains no personal information. Enter your desired password into the box labeled Pre-Shared Key. If you need help deciding on a strong password, our Choosing a Strong Password Guide can help.

Congratulations! You're finished. Just be sure to click SAVE before leaving the page.

Possible Problems when Changing your WiFi Settings

After making these changes to your router you will almost definitely have to reconnect any previously connected devices. This is usually done at the device itself and not at your computer.

Other ZTE ZXV10 W300 Info

Don't forget about our other ZTE ZXV10 W300 info that you might be interested in.

This is the wifi guide for the ZTE ZXV10 W300 v5. We also have the following guides for the same router: