Setup Router logo in white Setup router name logo in white
Get Software

Reset the Netgear Nighthawk R7000

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 6 minutes

This guide shows you how to reset your Netgear Nighthawk R7000 router. A router reset is very different than a router reboot. Rebooting a router is simply turning it off and back on again. This is different from a reset because a reset completely erases all settings from the router.

Warning: Proceed with caution; resetting your router can be a major headache. The following settings will be changed in your router:

  • The router's login and password are reset.
  • Your WiFi name and password are reset.
  • All ISP settings will reset to default, and you may have to contact your ISP.
  • Any parental controls, firewall settings, or port forwards will be removed.

A router reset is the last step you should take in recovering your router's password. Before you reset your router, you may want to try recovering your router password with our Router Password Finder.

Other Netgear Nighthawk R7000 Guides

This is the reset router guide for the Netgear Nighthawk R7000 v1.0.7.10_1.2.3. We also have the following guides for the same router:

Recover Password in Netgear Nighthawk R7000

If the only reason that you are resetting your router is because you forgot your router password, then you may want to try running our Router Password Finder instead of resetting your router.

Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Do not do a full router reset until after you have tried every other option to log in to your router.

Reset the Netgear Nighthawk R7000

On most routers you can find a small button on the back or the bottom labeled reset. Look at your router and try to find something that looks like this:

Router Reset Button

Reset buttons are usually tiny. Yours may look slightly different than this. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.

Hold the reset button down for about 10 seconds while watching the lights on the front of your router. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. It is harmless to hold the reset button too long.

Remember, this will erase everything you have previously done to this Netgear Nighthawk R7000 router.

Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Netgear Nighthawk R7000

After you are finished resetting your router, you need to login in using the original factory username and password. We have a Nighthawk R7000 Login Guide with all this information ready for you.

Change Your Password

Be sure to change your router's default password after you get logged back in. Leaving a router password set to default is a very serious security risk. You can follow our Choosing a Strong Password guide to help you pick a solid password for your router.

Tip: Write your new password down on a post-it note and stick it to the bottom of your router.

Other Netgear Nighthawk R7000 Guides

This isn't our only Netgear Nighthawk R7000 guide. We also have the following guides for this router.

This is the reset router guide for the Netgear Nighthawk R7000 v1.0.7.10_1.2.3. We also have the following guides for the same router: