Setup Router logo in white Setup router name logo in white
Get Software

Reset the Netgear Nighthawk R7000

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 6 minutes

In this article, you will learn how to reset your Netgear Nighthawk R7000 back to factory settings. A router reset is a much bigger deal than a router reboot. Every time your router loses power it reboots. This is very different from a reset, which erases a router completely and returns it to factory default settings.

Warning: Proceed with caution; resetting your router can be a major headache. When you reset your router, the following will happen.

  • The router's username and password are reset to factory defaults.
  • Your WiFi login, password, and network name are reset.
  • Any ISP settings saved in your router will be removed. You may have to contact your ISP.
  • Any firewall settings, parental controls, and port forwards that you have configured will be removed.

A router reset should be considered the last resort when you cannot log in to your router any other way. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.

Other Netgear Nighthawk R7000 Guides

This is the reset router guide for the Netgear Nighthawk R7000 v1.0.9.88_10.2.88. We also have the following guides for the same router:

Recover Password in Netgear Nighthawk R7000

If the only reason that you are resetting your router is because you forgot your router password, then you may want to try running our Router Password Finder instead of resetting your router.

Router Password Finder can save you a ton of time by recovering your lost or forgotten router password instead of doing a full router reset.

Router Password Finder - Automatically Recover Lost or Forgotten Router Passwords

Do not do a full router reset until after you have tried every other option to log in to your router.

Reset the Netgear Nighthawk R7000

On most routers you can find a small button on the back or the bottom labeled reset. This is what a typical reset button looks like:

Router Reset Button

Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.

Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Remember, this will totally reset your Netgear Nighthawk R7000 router.

Be sure to only reset your router if you have tried everything else, such as running our Router Password Finder software, which can find your lost or forgotten router password for you.

Login to the Netgear Nighthawk R7000

Now that you have finished resetting your router, you need to log in using the default username and password from the factory. Just follow our Nighthawk R7000 Login Guide to find all of the information that you need.

Change Your Password

Be sure to change your router's default password after you get logged back in. Since factory passwords are well known, it's a huge security risk to leave your router set to the default. You can follow our Choosing a Strong Password guide to help you pick a solid password for your router.

Tip: Write your new password down on a note and tape it to the bottom of your router for future reference.

Other Netgear Nighthawk R7000 Guides

We have collected a lot of information about the Netgear Nighthawk R7000 router. You can find some of our additional content here.

This is the reset router guide for the Netgear Nighthawk R7000 v1.0.9.88_10.2.88. We also have the following guides for the same router: