Setup Router logo in white Setup router name logo in white
Get Software

Reset the Netgear R6400

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 4 minutes

In this article, you will learn how to reset your Netgear R6400 back to factory settings. This is not the same thing as rebooting a router. Every time your router loses power it reboots. A Router Reset completely erases the router and returns it to factory settings.

Warning: Make sure that you fully understand the following before resetting your router. The following settings in your router will be changed:

  • The router's login credentials are reset to factory defaults.
  • Your WiFi login, password, and network name are reset.
  • Any ISP settings saved in your router will be removed. You may have to contact your ISP.
  • All parental controls, firewall settings, and port forwards will be removed.

Since a router reset is such a drastic step, it should only be done as a last resort when you cannot recover your router's password using any other methods. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Netgear R6400 Guides

This is the reset router guide for the Netgear R6400 v1.0.0.24_1.0.13. We also have the following guides for the same router:

Recover Password in Netgear R6400

Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.

Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Do not do a full router reset until after you have tried every other option to log in to your router.

Reset the Netgear R6400

Most routers have a small button on either the back or the bottom. Most reset buttons look like this:

Router Reset Button

Yours may look slightly different, but they are usually tiny. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.

Watch the front panel lights while you hold the reset button down for at least 10 seconds. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Do not be concerned about holding the reset button down too long. It will not hurt anything.

Keep in mind that this will completely reset your Netgear R6400 router.

This last step should only be taken if you have tried everything else, such as using our Router Password Finder software, which can recover lost or forgotten router passwords.

Login to the Netgear R6400

Now that you have finished resetting your router, you need to log in using the default username and password from the factory. Our R6400 Login Guide has all of the information that you need.

Change Your Password

You need to change your router's default password after you log in for the first time. It is a huge security risk to leave your router's password set to the factory default. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: Write your new password down on a note and tape it to the bottom of your router for future reference.

Other Netgear R6400 Guides

If you want additional help with your Netgear R6400 be sure to check out some of our other guides.

This is the reset router guide for the Netgear R6400 v1.0.0.24_1.0.13. We also have the following guides for the same router: