Setup Router logo in white Setup router name logo in white
Get Software

Reset the Technicolor CGM4140COM

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 9 minutes

This guide shows you how to reset your Technicolor CGM4140COM router to factory default settings. A router reset is a much bigger deal than a router reboot. Rebooting a router is simply turning it off and back on again. Resetting a router erases all settings from it and returns it to factory defaults.

Warning: Since this erases everything you have done to the router, there are some things you need to consider first. When you reset your router, the following will happen.

  • The router's login and password are reset to factory defaults.
  • All WiFi login information and network names are reset.
  • Your ISP settings are reset, which means you will have to contact your ISP to get them back.
  • Any firewall settings, parental controls, or port forwards that you have configured will be removed.

Resetting your router should be considered the last step. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Technicolor CGM4140COM Guides

This is the reset router guide for the Technicolor CGM4140COM 3.12p12s1 Shaw. We also have the following guides for the same router:

Recover Password in Technicolor CGM4140COM

Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.

Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.

Router Password Finder - Recover Lost or Forgotten Router Passwords

Just keep in mind that a router reset should be done as the last resort when you are unable to login to your router.

Reset the Technicolor CGM4140COM

Most routers have a small button on either the back or the bottom. This is what a typical reset button looks like:

Router Reset Button

Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.

Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. The blinking pattern of the lights on the front of the router should change when the reset is complete. You can hold the button down as long as you like, it will not hurt anything.

Keep in mind that this will completely reset your Technicolor CGM4140COM router.

Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Technicolor CGM4140COM

Now that you have finished resetting your router, you need to log in using the default username and password from the factory. We have a CGM4140COM Login Guide with all this information ready for you.

Change Your Password

Do not forget to change your router's default password when you log back into it. Since factory passwords are well known, it's a huge security risk to leave your router set to the default. Our Choosing a Strong Password guide can help you pick a strong password for your router.

Tip: Write your new password down on a post-it note and stick it to the bottom of your router.

Other Technicolor CGM4140COM Guides

If you want additional help with your Technicolor CGM4140COM be sure to check out some of our other guides.

This is the reset router guide for the Technicolor CGM4140COM 3.12p12s1 Shaw. We also have the following guides for the same router: