Arris TG1682G FirewallIPv6

This is the FirewallIPv6 screen from the Arris TG1682G router.



Keywords on The Arris TG1682G FirewallIPv6 Screenshot

The following words were detected on the Arris TG1682G FirewallIPv6 screenshot.

Xfinity   Skip to content Hi admin   •   Logout   •   Change Password 0% Internet Loading... Wi-Fi Loading... MoCA Loading... Medium Security Loading... Gateway At a Glance Connection Status XFINITY Network Local IP Network Wi-Fi MoCA Firewall IPv4 IPv6 Software Hardware System Hardware Battery LAN Wireless Wizard Connected Devices Devices Range Extenders Parental Control Managed Sites Managed Services Managed Devices Reports Advanced Port Forwarding Port Triggering Remote Management QoS DMZ Device Discovery Troubleshooting Logs Diagnostic Tools Reset/Restore Gateway Change Password Gateway > Firewall > IPv6 Manage your firewall settings. Select a security level for details. If you're unfamiliar with firewall settings, keep the default security level, Minimum Security (Low). Typical Security (Default): Allows all traffic from home network to internet and blocks all unrelated traffic from internet to home network. Custom security: Block specific services as per selection. Firewall Security Level Maximum Security (High) LAN-to-WAN: Allow as per below. HTTP and HTTPS (TCP port 80, 443) DNS (TCP/UDP port 53) NTP (TCP port 119, 123) email (TCP port 25, 110, 143, 465, 587, 993, 995) VPN (GRE, UDP 500, TCP 1723) iTunes (TCP port 3689) WAN-to-LAN: Block all unrelated traffic and enable IDS. Typical Security (Medium) LAN-to-WAN: Allow all. WAN-to-LAN: Block as per below and enable IDS. IDENT (port 113) ICMP request Peer-to-peer apps: kazaa - (TCP/UDP port 1214) bittorrent - (TCP port 6881-6999) gnutella- (TCP/UDP port 6346) vuze - (TCP port 49152-65534) Minimum Security (Low) LAN-to-WAN: Allow all. WAN-to-LAN: Block as per below and enable IDS IDENT (port 113) Typical Security (Default) LAN-to-WAN: Allow all. WAN-to-LAN: Block all unrelated traffic and enable IDS. Custom Security LAN-to-WAN : Allow all. WAN-to-LAN : IDS Enabled and block as per selections below. Block http (TCP port 80, 443) Block ICMP Block Multicast Block Peer-to-peer applications Block IDENT (port 113) Disable entire firewall Xfinity.com •   customerCentral •   User Guide