This is the RemoteManagement screen from the Arris TG1682G router.
The following words were detected on the Arris TG1682G RemoteManagement screenshot.
Xfinity Skip to content Hi admin • Logout • Change Password 0% Internet Loading... Wi-Fi Loading... MoCA Loading... Medium Security Loading... Gateway At a Glance Connection Status XFINITY Network Local IP Network Wi-Fi MoCA Firewall IPv4 IPv6 Software Hardware System Hardware Battery LAN Wireless Wizard Connected Devices Devices Range Extenders Parental Control Managed Sites Managed Services Managed Devices Reports Advanced Port Forwarding Port Triggering Remote Management QoS DMZ Device Discovery Troubleshooting Logs Diagnostic Tools Reset/Restore Gateway Change Password Advanced >Remote Management Remote Management allows the gateway to be remotely accessed by a customer account representative to perform troubleshooting or maintenance. Remote Management can be used via HTTP and HTTPS. Enable the HTTP option and enter the value for HTTP Port, then you can access your device from HTTP. For example,if the WAN IP address is 22.214.171.124 and the HTTP port number is 8080, then you would use http://126.96.36.199:8080 It's the same way to configure HTTPS. Select whether you would like to have Remote Management open to all Internet IP Addresses, an Internet IP Address range, or a single Internet IP Address. Remote Management HTTP: HTTPS: Remote Management Address (IPv4): Remote Management Address (IPv6): Please enable HTTP or HTTPS to configure Remote Access Allowed From. Remote Access Allowed From Single Computer IPv4 Address: . . . IPv6 Address: : : : : : : : Range Of IPs Start IPv4 Address: . . . End IPv4 Address: . . . Start IPv6 Address: : : : : : : : End IPv6 Address: : : : : : : : Any Computer Note:This option will allow any computer on the Internet to access your network and may cause a security risk. Global Management Telnet: SSH: Xfinity.com • customerCentral • User Guide